ACDelco ARM602-3 Manuel Informations Du Produit page 9

5. Sweat, oil and water can prevent a coin cell's terminal from making electrical
contact. To avoid this, wipe both terminals before loading a coin cell.
6. Coin cell life depends on coin cell quality and the amount of buzzer is used.
7. Dispose of coin cells in a designated disposal area. Do not throw coin cells into a
fire.
WARNING
side shields. Always remove battery pack before changing accessories or making
adjustments.
POWER ON
Press and release the Power Button (3) to turn the adapter on.
ZERO FUNCTION
When powers on, the digital torque tool can be zeroed at measure mode by press and
release the Power Button (3).
NOTE
Do not zero at the torque is applying on the digital torque tool.
HOW TO SET PEAK MODE OR TRACE MODE
Press and release the Down Button (4) or Up Button (5) to select the mode you need.
TRACE MODE: When in track mode the adapter will display real-time torque.
PEAK MODE: When in peak mode the adapter will hold the highest measured
reading on the display until "zero-clear" by pressing and releasing the Power button (3).
HOW TO SELECT UNIT
1. Press the Power Button (3) more than 2 seconds to Set Mode.
2. When you see the digits start blinking, press the Power Button (3) again to select the
desired measuring unit.
3. When the desired measuring unit is displayed, press the Power Button (3) 2 seconds
to confirm your selection. (or wait for 5 seconds the system will automatically
confirm your selection)
SETTING TORQUE ALARM VALUE
1. Press the Power Button (3) more than 2 seconds to Set Mode.
2. When you see the digits start blinking, press the Up Button (5) and Down Button (4)
discontinuously to adjust the target torque value.
1English1
OPERATION
To reduce the risk of injury, wear safety goggles or glasses with
English -8