SEVERIN KA 4190 Mode D'emploi page 11

The coffee maker is switched off, the LCD
display showing 12:00.
∙ To set the time, fi rst press the PROG key.
∙ The internal clock uses a 24-hour display
format. The current time is set by using
the H button for the hours, while the M
button is used to set the minutes.
Example:
∙ The current time is 15.30 (3 pm).
∙ Press the PROG key; the display shows
CLOCK.
∙ Press the H button repeatedly (or keep it
pressed for the necessary length of time)
until the LCD display shows 15:00.
∙ Press the M button (or keep it pressed)
until the LCD display shows 15:30.
∙ After around 15 seconds, CLOCK
disappears from the display and the
appliance is ready for use.
Timer
∙ To start the brewing process with a
delayed timer setting, you must fi rst set
the timer to the desired time.
∙ Press the PROG button twice. The LCD
display shows TIMER and the time last
entered, or 12:00.
∙ Use the buttons H und M to set the
desired time. (If no input is made
within 15 seconds, the TIMER indicator
disappears.)
∙ Press the On/Off button (I/0) twice to turn
the appliance on. The blue indicator light
AUTO comes on. At the pre-programmed
time, the coffee maker will automatically
switch on. The blue indicator light goes
out and the red light comes on.
On/Off button (I/0)
The On/Off button is used to switch between
the three settings 0-I-AUTO:
0 - The appliance is switched off.
No indicator light is on.
I - The appliance is switched on. The
red main indicator light
AUTO - The appliance automatically
switches on at the pre-
programmed time. The blue
indicator light AUTO comes on.
Aroma function
To obtain a stronger coffee fl avour, the
appliance is equipped with a special aroma
function. With this setting, the hot water
is released at intervals. This is especially
useful when preparing smaller quantities
of coffee. To select this function, press the
On/Off switch for about 2 seconds until the
indicator light begins to fl ash.
Note: This feature is not available when
using the timer function with a pre-selected
starting time.
Before using for the fi rst time
Before making coffee for the fi rst time,
let the appliance go through two or three
fi ltration cycles using the indicated maximum
amount of cold water, but without using
ground coffee. This should also be done
if the appliance has not been used for an
extended period of time, and after descaling.
General information
∙ A measuring scale on the water container
and on the glass carafe facilitates fi lling
the container with the correct amount
of clean water. With a dual-scale, the
left scale is used for regular-sized cups
of approx.125ml, while the right scale is
used for smaller cups. Make sure that the
indicated maximum amount of water is not
comes on.
11