Reversing The Access Door - Hatco FLAV-R-FRESH Manuel D'installation Et D'utilisation

INSTALLATION

Reversing the Access Door

The Flav-R-Fresh access door(s) may be hinged on either the
left or right side for convenience. Use the following procedure
to reverse the access door.
NOTE: For models equipped with a motorized rotating rack
(FDWD-1, FDWD-2, and FDWD-12-1), the "Relocating
the Proximity Switch" procedure in this section must be
performed after reversing the access door(s).
1. Remove the top hinge pin screw that holds the door to the
hinge bracket.
2. Tip the door assembly forward (away from cabinet) and lift
gently to clear the bottom hinge bracket. Remove the nylon
washer(s).
3. Reinstall the top hinge pin screw.
4. Remove the fluorescent lamp cover to allow access to the
hinge bracket/striker plate hardware.
5. Remove the screws holding the hinge brackets to the cabinet.
Hinge Assembly
6. Remove the screws from the striker plates on the non-hinge
side of the cabinet.
7. Install the striker plates on the opposite side of the cabinet
where the hinge brackets were previously mounted.
8. Install the hinges on the opposite side of the cabinet where
the striker plates were previously mounted using the original
hinge bracket mounting screws.
9. Replace the fluorescent lamp cover.
10. Carefully rotate the door 180°.
11. Remove the hinge pin screw from the end that is now the
top.
12. Carefully place the door assembly with the nylon washer(s)
into the bottom hinge bracket.
13. Tip/tilt the door assembly towards the cabinet and align the
door top with the hinge bracket. Reinstall the top door hinge
pin screw through the hinge bracket and into the door top.
Striker Plate and
Hardware
Top Hinge
Pin Screw
Lamp
Cover
Reversing the access Door
8
English
Door Rotated 180°
Bottom Hinge Pin Screw and
Nylon Washer(s)
Form No. FDWDm-0915