Monitor Settings - Fermax 1L VDS NCITY VIDEO Manuel D'installation Et Utilisation

Kit Video VDS Kit Video VDS Kit Video VDS Kit Video VDS
Kit Video VDS Kit Video VDS Kit Video VDS Kit Video VDS Kit Video VDS Kit Video VDS

MONITOR SETTINGS

To set up the different monitor parameters, it is necessary to access the configuration mode.
To access configuration mode, press the «
second and a confirmation tone is heard.
Call Volume Setting
When in configuration mode, press the
volume.
Call Tone Selection and Call Cancellation
When in configuration mode, press the «
Now, press the
-
Press « » to activate Call Cancellation.
The monitor led blinks on red to indicate «do not disturb» mode.
Image Configuration
Press the button againin tone selection
indicating that the monitor is in image configuration mode.
The monitor has 4 pre-established configurations with a certain level of shine, contrast and
colour.
Press the button «+» to alternate sequentially between the different shine and contrast
configurations.
Press the button «
(5 sec.)
Enter
configuration
mode
«+»
«+»
button to change the monitor call tone.
(When you reach the first or last configuration option a warning tone will sound).
-
» to alternate sequentially between the different colour configurations.
» for 5 seconds. The LED blinks once per
button to select high volume or «
» button again.
. The LED flashes once every two seconds,
-
» to select low
Set call volume
Select call tone and call
cancellation
Image configuration
Pag 35