Fermax 1L VDS NCITY VIDEO Manuel D'installation Et Utilisation page 34

Kit Video VDS Kit Video VDS Kit Video VDS Kit Video VDS Kit Video VDS Kit Video VDS Kit Video VDS Kit Video VDS Kit Video VDS Kit Video VDS
BUTTONS
Audio Activation Button and Autostart
Monitor:
· Colour
between the entry panel and the residence is open; operating in hands-free mode.
· B/W Monitor: When a call is received, press the button
With the monitor on standby, hold down this button for 1 second to switch the monitor on manually (video
only). Press the button
Lock Release / Call Guard Unit Button
· The lock-release is activated by pressing the button with the monitor activated.
· Pressing this button whilst the monitor is on standby will result in a call being made to the
guard unit (where one exists).
Hang-Up Button / Main-Secondary Camera Selection / Menu
· Press to terminate communication.
· With video, hold this button
the main camera and the secondary camera (where one
· With the monitor on standby, hold down this button for 2 seconds to go into monitor
configuration mode. See the "Monitor Settings"
F1
F1 and F2: Buttons for Additional Functions
(assigned by the installer).
OPERATION
Answering a call
When the call button on the Entry Panel is pressed a call tone is emitted both from the panel and
on the monitor, causing the screen to start up.
· Colour Monitor: Press the button
panel and the residence is open; operating in hands-free mode.
· B/W Monitor: Press the button
e communication facility will automatically terminate after 90 seconds, or at any time
Th
by pressing the button
If communication is not established with the street panel, the monitor will automatically go off after
30 seconds.
Opening the door
When a call is received from the entry panel, it is possible to open the door at any time, by
pressing the button
Manual Activation of the Monitor (Auto-start)
With the monitor on standby, hold down this button
manually. To sequentially select between the main camera and the secondary camera (where one
exists), hold the button
To activate audio and talk to your visitor or open the door, take the steps described above.
If communication is not established with the entry panel, the monitor will automatically go off after
30 seconds. The communication facility will automatically terminate after 90 seconds, or at any
time by pressing the button
Pag 34
When a call is received, press this button
again to get audio.
/
to speak to the visitor. The audio channel between the entry
to talk to the visitor and release it to listen.
. The LED will remain off whilst the conversation is underway.
.
/ down for 2 seconds.
.
NOTE:
The monitor screen
goes on once the call
from the panel has
ended.
to speak to the visitor. The audio channel
to talk to the visitor and release it to listen.
down for 2 seconds to sequentially select between
exists).
section.
F1: _____________________________________
F2: _____________________________________
for 1 second to switch the monitor on
ENGLISH