Walter Walu Pool Woodstar Notice D'installation page 16

Walu Pool
Woodstar
6. Pass the strap in the adjustable fastener leaving enough slack to be able to slot
the fastener onto the hook (No. 3).
Once the adjustable fastener is engaged in the hook, pull on the strap to place
the profile on the storage side under tension. Repeat the operation for each
fastener.
7. IMPORTANT: stand at the other end of the pool, facing the part that is already
fixed. The ratchet tighteners must be positioned 10 cm from either end of the
winding tube. Then position the other ratchets at equal distances. If the cover has
a stairwell flap, also fix the ratchet tighteners at the same place as the straps.
Repeat operation 5, placing the hooks opposite each strap and ensuring they are
at least 40 cm away from the edge of the pool.
Place the rounded part of the ratchet (normally intended to pass the strap through
before sewing) in line with the
Fix the strap into the slot in the ratchet spindle, then activate the handle so as to
roll the strap around the spindle in order to fully tighten the cover. Finish
tightening the cover by leaving the handle in the horizontal position.
8. Once the cover is tight, the eyelets are in their final positions.
Repeat operation 5.
Hook one end of the bungee cord in the eyelet, pass the bungee cord through
the hook and attach the other end in the initial
9. In the case of a cover with a cut-out for a filtration unit or ladder, first position the
cover on the ladder side, passing the ladder upright into the two holes. All the
straps on the end of the cover must have a ratchet tightener (see point 7). In
order to keep the cut-outs tight, fix a ratchet tightener on the cross strap (or two
straps). To do so, thread the two straps that are opposite each other into the
same ratchet. Tighten the ratchet, but do not over-tighten.
IMPORTANT:
The hooks must be fixed on a solid wall at least 20 mm thick and
in strict compliance with the installation instructions.
Installation instructions
hook.
eyelet.
4 / 6