Using The Alarm - LENCO DAB-11 Mode D'emploi

Radio fm dab+
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Using the alarm

Alarm Setting
With radio on, press and hold the Info/Menu button.
Then press the Prev or Next button to choose Alarm 1 to ON position, press Enter/Snooze button to
confirm.
The hours will flash, use the Prev or Next button to select hour. Press Enter/Snooze button to confirm.
The mins will flash, use the Prev or Next button to select the minutes. Press Enter/Snooze button to
confirm.
The Vol digit will flash, use the Prev or Next button select the Volume. Press Enter/Snooze button to
confirm.
The Mode: Alarm will flash, use the Prev or Next button select the Alarm source: Alarm/DAB/FM. Press
Enter/Snooze button to confirm.
With radio on, press and hold the Info/Menu button.
Then press the Prev or Next button to choose Alarm 2 to ON position, press Enter/Snooze button to
confirm.
The setting procedures is the same as the "ALARM1".
NOTE: You can press the Info/Menu button to get back last one step when in the process of the setting
the alarm.
Deactivate the alarm
Press and hold the Info/Menu button, then select the alarm you wish to turn off using the Prev or Next
button to choose the Alarm to OFF position.
Press Enter/Snooze button.The alarm will be deactivated.
Turning off the alarm
Press the Power/Standby button to turn off the alarm when the alarm is sounding.
NOTE: The alarm will keep ringing for 1 hour if you do not turn it off when it is sounding.
Snooze Function
When the alarm is sounding, press the Enter/Snooze button to turn off the alarm temporarily. The
alarm will be delayed for 9 mins and then come on again.
Station information on DAB mode
Every time you press the Info/Menu button in the DAB mode, the display will cycle through the
following display modes:
Dynamic Label Segment (DLS): Displays scrolling text information supplied by the broadcaster.
Signal Strength: Displays a signal bar with the current station strength.
Bit Error Rate (BER): Provides details of the signal error rate.
Channel Frequency: Displays the station's transmission channel number and frequency.
10

Publicité

Table des Matières
loading

Table des Matières