Charging Procedure - Kenwood KSC-32S Mode D'emploi

charGInG ProceDure

Do not use in explosive atmospheres (gases, dust, fumes, etc.).
ATTENTION: Always switch OFF a transceiver equipped with a
battery pack before inserting the transceiver into the charger.
1
Plug the AC adapter cable into the
adapter jack located on the rear of the
charger.
2
Plug the AC adapter into an AC outlet.
3
Slide a battery pack or a
transceiver equipped with a battery
pack into the charging slot.
• Make sure the metal contacts of
the battery pack mate securely
with the charger terminals.
• The indicator lights red and
charging starts.
4
When charging is completed, the indicator flashing green.
Remove the battery pack or the transceiver from the charging
slot.
• When the charger will not be used for a long time, unplug
the AC adapter from the AC outlet.
4