How To Use; Practice First; Surface Prep - Homeright FINISH MAX PRO Manuel D'instruction

PRACTICE FIRST

Practice spraying water on newspaper or cardboard. This will give you the feel of the sprayer and
familiarize you with its features. Follow the instructions for adjusting to the proper spray pattern.
1. Make sure the spray tip is screwed on tightly. Familiarize yourself with the spray cap: Turn its wings
to adjust to a horizontal or vertical spray pattern. (See Figure A.)
2. Remove the container from the spray gun by turning it counterclockwise.
3. Firmly insert the pick-up tube. (See Figure B.) Place the pick-up tube with its angle pointing forward
if you'll be spraying mostly in the downward direction, and place it facing backward if you'll be
spraying mostly in an upward direction. This tube placement can be adjusted/changed at any time
during your project.
4. Fill the container with water and re-fasten it.
5. Plug in the sprayer and turn on.
6. Engage the trigger and wait a few seconds for the unit to start spraying the water.
7. Turn the volume control knob fully clockwise to get maximum flow. Then, turn it counterclockwise
and notice how the spray pattern changes in width and intensity. Adjust this knob until you get a
good spray pattern. (See Figure C.)
NOTE: The best distance for spraying is 4 to 10 inches from the surface you're spraying. Too far
away may result in overspray (and wasted liquid), and too close may cause liquid build-up (runs)
(see Figure D).
8. Keep a stiff wrist. Do not arch your wrist at the beginning or end of the stroke. (See Figure E.)
Do not stop the motion of the unit while spraying. The path of the sprayer must pass beyond the
area being sprayed, and the switch must be triggered on and off as the sprayer passes into and out
of the spraying area. (See Figure F.)
NOTE: Stopping the motion of the sprayer or swinging into a new stroke pattern while spray is
being delivered will result in heavy spray build-up at the edges of the stroke.

SURFACE PREP

Thoroughly clean all objects and surfaces to be sprayed before spraying material on them. You may
want to mask or cover areas not intended to be sprayed.
SMALL PROJECTS
This sprayer uses airflow to transfer liquid to the work piece. It is recommended that for small projects,
the user first tests the sprayer without adding liquid to the cup. The airflow may cause small pieces to
move or fall during operation. Use caution and good judgement before spraying liquid.

HOW TO USE

FINISH MAX PRO FINE FINISH SPRAYER
(C800850)
6
A
B
C
D
4-10 inches
E
Correct Incorrect
F
Start Trigger Release End
ENGLISH