Operating The Robot; Notes Before Cleaning - ECOVACS ROBOTICS WINBOT7 Mode D'emploi

3. Operating the Robot

3.1 Notes Before Cleaning

Do not use WINBOT 7 on a framed window with
a frame smaller than 5mm (0.2").
WINBOT 7's Back-Up Battery must be fully
charged before use. Plug WINBOT 7 in,
move the Power Switch to the CHARGE
position, and charge until the Status Indicator
Light glows a continuous GREEN.
Please ensure there is a 15cm (5.9") clearance between the glass and obstacles in the room
like curtains or furniture.
WINBOT 7 can clean horizontally mounted glass, or glass mounted at an angle, using the
Direction Control Buttons on the Remote Control.
Do not use WINBOT 7 upside down.
Do not use WINBOT 7 on windows with an uneven surface, such as decaled, frosted, textured,
patterned, or coated glass.
WINBOT 7 should only be used with WINBOT Cleaning Solution. Using other cleaners
significantly reduces WINBOT's performance and can damage the robot.
6 6
EN
60
WINBOT 7 can be used on framed or frameless
windows larger than 45cm x 60cm (17.7'' x
23.6''). (*W730 only)
If the window is covered with dirt, clean a
small area on the glass before use and place
WINBOT 7 there.
45