Femi 350 PLUS Mode D'emploi Et Entretien page 12

2. Align the motor-with-drum assembly for placing the bags. Place the gasket and the protection net in between the two
parts to be assembled, using the screws, the washers and the corresponding nuts (Fig. 3).
3. Secure the two supports of the manifold with supports
onto the motor assembly using the screws, the washers
and the corresponding nuts (Fig. 4).
4. Position the base onto the wheels and position the motor and drum assembly onto the base aligning the supports with
the holes on the base. Insert the screws and the washers and fix the supports to the base. Tighten the screws using
the appropriate wrench. Pay attention when positioning the directional wheels that must be on the side of the bags
opposite the motor. (Fig. 6).
5 Fix the bag hook to the motor-drum assembly. Align the two holes of the support to those of the drum and then use
the screws and washers to secure the support to the drum. Tighten all the way (Fig. 7).
10
Mount the remaining supports with the supports and do
not forget to simultaneously secure the handle to the
drum that secures the bags. (Fig. 5).
Fig. 4
Fig. 3
Fig. 5