Brother PRSCLPM1 Manuel D'installation page 5

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
3 Install and tighten the two thumb screws
removed in step
● Please firmly tighten the two thumb screws
with the disc-shaped screwdriver included
with the embroidery machine. The wrong
frame size may be indicated on the
machine's screen if the two screws are not
tightened.
4 Use both hands to grasp the frame with
hooped item, and then attach it to embroidery
frame holder D.
5 Insert the pins on embroidery frame holder
D into the holes on both sides of the clamp
frame to secure it.
1 Make sure that the pins on the embroidery frame
holder fit into the positioning holes on the
embroidery frame.
1
.
Note
■ Removing the clamp frame
While grasping the clamp frame with both
hands, lift up both springs with your fingers, and
then pull off the clamp frame toward you.
Note
● Be careful not to pinch your fingers with
the springs.
Memo
● The clamp frame allows you to easily
rehoop the fabric without removing the
embroidery frame from the machine,
being careful not to bend the clamp frame.
Following steps
when hooping the fabric.
3/3
1 4
through on page 1