Wifi Setup For Iphone™, Ipad™ And Ipod Touch - Elinchrom EL-Skyport RX WiFi Manuel D'utilisation

WIFI SETUP FOR IPHONE
IPAD AND IPOD TOUCH
™
Find the WiFi Setup guide also in the EL-Skyport iPhone™ App
under Information!
1. Switch ON the EL-Skyport RX WiFi module and wait
approx. 5 seconds until the module is completely
configured.
2. Open the Settings of the operating software on your
iPhone™, iPad™ or iPod touch™.
3. Select WiFi and wait until the EL-Skyport WiFi
network is listed.
4. Select the EL-Skyport WiFi network, named EL-SP-
WiFi-xxxx, (xxxx indicates the serial number of your
EL-Skyport WiFi module).
5. Open the network settings by selecting the blue arrow
on the right of the name of the network.
6. IP Address: Select Static.
7. Set IP Address to 169.254.1.5 (169.254.1.3 up to
169.254.1.254 are available).
8. Set Subnet Mask to 255.255.0.0.
9. Leave all other fields blank.
10. If the ios version of your device is older than 4.3, you
may select Auto-Join in order to join automatically the
EL-Skyport Wi-Fi network when found by your device.
11. Exit the settings and go to the EL-Skyport Mobile
Remote Application.
12. You may have to go back to the settings and select
your usual WiFi network after use, if the change was
not automatically applied after turning off the EL-
Skyport WiFi module.
6
,
™
™
5
10
6
7
8