Mounting The Phone On A Wall - Sony IT-B7 Mode D'emploi

Mounting the phone on a wall

1
Remove the hang-up tab.
2
Reverse the hang-up tab upside down and insert it back.
3
Attach the wall bracket to the center of the phone.
4
Plug one end of the shorter telephone line cord (supplied) into the
LINE jack and the other end into the telephone outlet.
5
Hook the phone to the wall plate.
2
1
Telephone
line cord
5
Wall plate
Tip
To remove the wall bracket, press the lower tabs.
Maintenance
On handling
• Do not attempt to disassemble the casing. Refer servicing to qualified
personnel only.
• Do not put foreign objects into the unit. Should any liquid or solid object fall
into the unit, unplug the unit and have it checked by qualified personnel
before operating the unit any further.
• Do not drop the unit as a malfunction may result.
On cleaning
Clean the cabinets with a soft cloth slightly moistened with water or a mild
detergent solution. Do not use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine as they may damage the finish of the cabinet.
If you have any questions or problems concerning your phone, please consult
your nearest Sony dealer.
3
1
Wall
bracket
2
4
Troubleshooting
Symptom Remedy
You hear no dial tone. • Make sure the telephone line cord is securely
connected to the telephone outlet.
The phone does not connect at • Make sure the dial mode setting (pulse or tone) is
all, even the numbers you dial correct.
are correct.
The phone does not ring. • Set the RINGER LEVEL switch to H or L.
The phone does not redial • Make sure the last dialed number is really the one you
correctly. want to dial.
• Make sure the number (including the tone and pause
You hear five short error beeps
digits, if used) you last dialed does not exceed 32
when you try to redial.
digits.
• Make sure there is a phone number correctly stored in
The phone does not make a
the speed dialing.
speed dialing call.
• Store the desired phone number once more.
• You entered a dialing key to which no phone number
You hear five short error beeps
has been stored.
when you try to make a speed
dialing call.
• Make sure you correctly follow the procedure for
You cannot store a number for
storing the number.
the speed dialing.
• Make sure the number (including the tone and pause
You hear five short error beeps
digits, if used) does not exceed 16 digits.
and cannot store a number on a
speed dialing call.
Specifications
Dial signal Tone, 10 PPS (pulse) selectable
Approx. 165.5 × 84 × 219 mm (w/h/d)
Dimensions
(Approx. 6 5/8 × 3 3/8 × 8 5/8 inches)
Mass Approx. 510 g
(Approx. 1 lb 2 oz)
Supplied accessories Telephone line cords (2)
Wall bracket (1)
Design and specifications are subject to change without notice.