GARDENIQUE Serenity Instructions D'utilisation page 5

STEP 3 - ATTACH THE CHECK VALVE
Assemble the check valve, inlet and gasket
snugly on either side of the fountain unit.
Make sure that the inlet adapter is pointed
in the same direction as the spillway. If
not, carefully turn the adapter. Do not over
tighten.
STEP 4 - ATTACH THE FOUNTAIN
TOPPER
Connect tubing to the inlet on the bottom of
the fountain unit. A hose clamp can be used
for a more secure fitting (not included).
STEP 5 - ATTACH THE PUMP
Connect the tubing to the pump using the
supplied adapter.
Place the pump inside the basin. Route the
tubing and power cord through the notch
in the basin. Tubing can be cut if too much
excess is present.
STEP 6 - FILL THE BASIN
Fill the basin and fountain unit with water
then install the lid.
STEP 7 - PLACE AND TEST
To ensure pump flow is set appropriately
and the water is flowing into the basin, place
the fountain unit on the ground behind the
basin. Check to make sure the tubing is in
the trench and the fountain topper is level.
Once in its final location, plug in the pump.
Check for leaks and adjust accordingly, then
backfill the hole with dirt.
STEP 8 - ADD THE ROCKS
Wash decorative gravel to remove small
debris.
Decorate top of the basin with decorative
gravel, plug in the pump, and enjoy!
VISIT WWW.GARDENIQUEDECOR.COM FOR PRODUCT INFORMATION AND TIPS.
(NOT INCLUDED)
3