Overview, Before You Start, And Step By Step Installation - GARDENIQUE Serenity Instructions D'utilisation

OVERVIEW
BEFORE YOU START
Safety. Always dig with caution. Call 811 or your local utility company before you begin
digging to locate buried pipes or power lines on your property.
Location. Consider how the water garden will enhance your landscape. Make sure the
area won't easily become covered with debris and obstruct the fountain.
Elevation. Your water feature should not be built on a slope or grade. If it is located at the
lowest elevation of the yard, you will have rainwater run-off that can muddy the water.
Leveling. For locations where ground is hard, use sand to help level and fill in gaps.
Water. To ensure continuous operation, regularly top off your water level, especially in
hot weather. If your feature is close to a sprinkler, it can help keep the basin full.
STEP BY STEP INSTALLATION
STEP 1 - PLAN
Layout and mark appropriate basin area.
Decide where the fountain topper will sit.
The water should flow into the middle of the
basin.
STEP 2 - DIG A HOLE
Dig a hole 25" long x 13" wide x 12" deep
for the basin. Also, dig a narrow trench
approximately 10" long x 2" wide x 3" deep
for the tubing. Place the basin inside the
hole. Ensure basin fits and level basin within
excavated area.
2
VISIT WWW.GARDENIQUEDECOR.COM FOR PRODUCT INFORMATION AND TIPS.
FOUNTAIN PUMP WITH FLOW CONTROL
300 GPH, ETL Certified Pump with 10 ft. power cord
ENDURALITE FOUNTAIN TOPPER
TM
Weatherproof, earth-friendly recycled materials
23.2 x 23.1 x 8.9 in.
TUBING
3/4 in. ID tubing
7 GALLON BASIN
Durable plastic and easy pump access
26.9 x 12.9 x 12 in.