Important - Carbon Heater CHD Mode D'emploi

Operating Instructions
Waterbed heater Type: CHD 230V 100-300W
Please read advices carefully before you install and use the heating system.

Important!

The applicance may be used by persons (including children older than 8 years) with reduced physical,
sensory or mental capabilities or lack of experience and knowledge, when they are supervised or after they
were instructed in the safe use of the applicance and have understood the potential resulting danger. The
applicance is not intended to be used by playing children.
The device contains no maintainable parts. Cleaning must not be performed by children without supervi-
sion. The heating system must only be used for heating filled water beds. The heating element is intended
to be mounted on firm surfaces only and must not be positioned on soft surfaces or carrier materials. Just
the LS versions with integrated plate may be mounted on soft surfaces or carrier materials. Any use other
than that for the intended purpose will render the warranty void and cause all liability claims against the
manufacturer to be excluded.
The heater system is designed for connection to a 230V AC power source.
The thermostat must not be covered over or located behind the bed. Air
must be able to circulate to it!
The heater is not intended for use in hospitals.
When filling or emptying the waterbed mattress, always unplug the heater
system from the electricity mains. The heating element must not be crea-
sed or folded.The heating element heats over the whole surface. Therefore
no part of the heating element must be located under the foam insulation
of the sides of the bed or under the division of a split mattress. The heating element must only be opera-
ted with the thermostat type CHA or CHD115V/230V 100-300W which is supplied with it. Direct connec-
tion of the heating element to the mains network will cause the warranty to become extinct and will render
all liability claims against the manufacturer void. Sharp-pointed objects such as sewing needles and pins
must not be stuck into it. Bedding must not come into contact with the heating element. The connection
leads of the device (lead for connection to the mains and connection wire to the heater element) cannot
be replaced. If a lead becomes damaged, the device must no longer be used.
The connection plug from the heating element to the thermostat (see Fig. 1) is only intended for assembly
of the waterbed and must only be fitted by qualified personnel.
Assembly of heating element beneath water bed mattress
• Plug in the mains lead to the electricity mains. Set temperature to maximum temperature. The heating
element should start to become warm after a few seconds. When this is found to be the case, im-
mediately unplug the cable from the mains; failure to do so will cause the heating element to
switch off permanently and the warranty to become extinct!
• Ensure that the leads are not trapped between the substructure and frame. Place the heating element
with the printed side upwards making sure there are no folds or creases. Do not position the heating
element on uneven surfaces such as joints or seams. Make sure that the heating element is comple-
tely covered by the protective film of the water mattress. Neither the protective film nor the water
mattress must cause any folds or creases.
• The water mattress must have minimum dimensions of 60 cm x 140 cm and be filled with a water
depth of at least 5 cm.
• When the bed has been completely installed and the mattress is filled with water, the heater can be
connected to the power supply. The desired temperature can be set.
6
Figure 1