General Information; Safety Information; Use Of Hazard Information - Hach FT660 sc Manuel D'utilisation De Base

Specification
Drain fitting
Tubing requirements
Dimensions
(W x D x H)
Mounting options
Shipping weight
ASTM conformance
Limit of detection (LOD)
Protection class
Pollution degree

General information

In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.

Safety information

Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.

Use of hazard information

Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or serious
injury.
Indicates a potentially hazardous situation that may result in minor or moderate injury.
Indicates a situation which, if not avoided, may cause damage to the instrument. Information that requires special
emphasis.
4 English
Details
½-in. NPT female, ½-in. hose barb
Sample inlet: ¼-inch OD rigid or semi-rigid tubing
Drain: ½-inch ID flexible plastic tubing
25.4 x 30.5 x 40.6 cm (10 x 12 x 16 in.)
Wall mounted or floor stand
Turbidimeter and controller—16.31 kg (13.5 lb)
Turbidimeter only—4.71 kg (10 lb)
D6698 Standard test method for online measurement of turbidity below 5 NTU
0.296 mNTU (ISO 15839)
III
2/II
D A N G E R
W A R N I N G
C A U T I O N
N O T I C E