Shelving Configurations - Northland 15 Instructions D'installation, D'utilisation Et D'entretien

Loading Tips and Suggestions
Your appliance is equipped with either a cantilever shelf system (refrigerator or beverage center) or a rollout
shelf system (wine refrigerator) which provide maximum adjust ability and customizing of the shelving
arrangements listed below.
Refrigerator or Beverage Center:
24" model shown in Figure 12.
(2) perforated
metal
cantilever
shelves.
(See Figure
12a).
Perforated metal shelf
CAUTION
!
To Add or Remove a Cantilever Shelf
Remove stored product from the shelf. Do not try
to remove a loaded shelf from the refrigerator.
Grasp the shelf front with both hands, rotate the
front upward and lift out. (See Figure 14). To install
a shelf insert the shelf in the appliance and insert
the top hooks into the shelf support slots and drop
the shelf down so the hooks drop over the bottom
of the slots.
CAUTION
!
Make sure your cantilever shelf is secure on the
shelf supports by pressing down on the shelf before
loading.
Installed shelf tang
Rear tang
(hook) on
shelf
Figure 14

SHELVING CONFIGURATIONS

Figure12
Figure 12a
Never try to move a loaded shelf, remove everything from the
shelf before moving. Use both hands when moving the shelf.
Shelf support slot
Wine:
15" model shown in Figure 13.
(5) glide out
wine racks.
(See Figure
13a).
To Remove a Glide Out Shelf
• Extend the shelf out of the cabinet until it stops.
• Unload the shelf.
• Lift up on the front of the shelf and pull forward to
disengage the slide stops.
• Remove the shelf from the cabinet.
(See Figure 14a).
Figure 14a
11
Figure13
Figure 13a
Glide out wine rack
Lift up on the
front of the shelf