Using Your Electronic Control; Starting Your Refrigerator; Turning Your Refrigerator On Or Off; Set The Temperature - Northland 15 Instructions D'installation, D'utilisation Et D'entretien

USING YOUR ELECTRONIC CONTROL

Alarm
Set Colder
Press and Hold
Figure 10
close-up of control

Starting your refrigerator

Plug the refrigerator power cord into a wall outlet.
Your refrigerator will begin cooling after power is
applied.
If your refrigerator does not start, check that the
refrigerator is turned on and the set temperature is
cold enough.

Turning your refrigerator ON or OFF

If the refrigerator is on, the refrigerator temperature
will be shown on the display. To turn the refrigerator
off, press and hold the "ON/OFF" button for three
(3) seconds. "OFF" will appear on the display.
If the refrigerator is not on, "OFF" will be shown on
the display. To turn the refrigerator on, press and
hold the "ON/OFF" button for three (3) seconds.
The refrigerator temperature will be shown on the
display.
Set temperature
To set the refrigerator temperature, press and
hold the "SET" button. When the "SET" button is
pressed, the display will show the set tempera-
ture. While holding the "SET" button, press the
"WARMER" or "COLDER" buttons to adjust set
temperature.

Refrigerator operation

The available temperature range for your unit is:
Beverage Center 34° to 42°F (1° to 6° C)
Refrigerator 34° to 42°F (1° to 6° C)
Wine 40° to 65°F (4° to 18° C)
It may take up to 24 hours for your refrigerator to
reach desired temperature. This will depend on
amount of content loaded and number of door
opening and closings.
For best results allow refrigerator to "pull down"
to desired set temperature before loading. Once
contents are loaded, allow at least 48 hours for
temperature to stabilize before making any adjust-
ments to the set temperature.
F
Warmer ON/OFF
Press and Hold
Control

Alarms

Your control will monitor refrigerator function and
alert you with a series of audible and visual alarms.
•Door Ajar Alarm: If the door has
been left open for over five (5)
minutes, the alarm will sound in one
(1) second intervals. The display panel will flash
"do" and the Alarm LED located at the top left of the
display below the word "Alarm" will be illuminated.
This will stop as soon as the door is closed.
•Temperature Sensor Fault: If the
controller detects that the tempera-
ture sensor is not properly function-
ing, a temperature sensor alarm will sound in one
(1) second intervals. "E1" will flash on the display
panel and the Alarm LED located at the top left of
the display below the word "Alarm" will be illuminat-
ed. Please call Customer Service or your dealer if
this error code is displayed.

Alarm Mute

Press any key to mute the audible portion of an
alarm.
NOTE
This action will only mute the alarm. If the condition
that caused the alarm continues, the alarm code
will continue to flash and will sound for 20 seconds
every 60 minutes.
10
Figure 11
Control
Assembly
Door Switch