Inserting Modules; Removing Modules - Miele A 503 Mode D'emploi

en - Areas of application

Inserting modules

Removing mod-
ules
34
A bar can be inserted into the top level. The bar supports modules
that are disconnected from the water connection of the top level.
This prevents modules from falling onto the load in the mobile
unit's bottom level.
Plug the module connector into the water connection of the mobile

unit at a flat angle.
Then push the module's retainer slightly towards the water inlet 

and lower the module  to lock it in place behind the struts of the
mobile unit.
Modules with holder rack
In the bottom level of the mobile unit, insert the modules in the two
outer positions first so that they can be pushed behind the mobile
unit's side bars. Then insert the module in the middle position.
Push the module's retainer slightly towards the water inlet  and

pull it out from behind the struts of the mobile unit .
Disconnect the module from the mobile unit's water connection and

remove it.