3.14. POOL Menu
User menu
/
DHW/Legionell prot
Pool
Informtion
/
Pool
Enble
Winter progrm
Minutes per hour
Pool
Enble
Remote ontrol OFF
SetT
DTstrt
Auxiliry pool X
Emergeny
Support
C
3.15. INFORMATION Menu
Press
for quick access to the information menu from the main screen.
User menu
/
Pool
Informtion
Alrms
/
Brine/Prodution
Brine
Outlet
C
Inlet
C
DT
Press
Pumps
XXXXXX XXXXXX
Ground
OutT
InletT
Rtio
FOP
DT ir unit
DTdefrosting
Outdoor temperture
OutdoorT
Pool
Used to enable the POOL mode.
In versions for ecoGEO B and ecoGEO C, it can be used to adjust the percentage of
minutes/hours that the heat pump is dedicated to the POOL mode when there are
simultaneous demands for heating and pool during the WINTER program.
In versions for ecoGEO HP, it can be used to adjust the setpoint temperature and the
start-up temperature differential of the pool.
C
The
icon indicates that there is a time schedule activated in the POOL mode.
C
Auxiliary pool X
This is used to enable the auxiliary POOL system in both EMERGENCY and SUPPORT
mode.
In EMERGENCY mode, the auxiliary system is activated automatically if there are any
active alarms that prevent compressor start-up.
In SUPPORT mode, the auxiliary system is activated automatically for normal POOL
production, as programmed by the technical service.
Brine/Production
Het
This shows the inlet and return temperatures, temperature difference, current pressure
C
and the percentage of circulator pump regulation in the brine and production circuits.
br
%
Hybrid / Heat Unit System
Air
C
In hybrid brine systems (geothermal-aerothermal), it displays the inlet and return
C
temperatures and the percentage of energy absorption in each brine system. It also
%
displays the air-antifreeze temperature difference, the aerothermal operation factor
C
C
(FOP) and the estimated setpoint for the defrost program to start up.
In exclusively aerothermal brine systems, it only displays aerothermal information.
Outdoor temperature
Shows the current outdoor temperature.
C
46
User manual ecoGEO