Level Button; Time- Out; Cleaning And Maintenance; Procedure To Follow If The Appliance Is Not Going To Be Used For Some Time - Lotus cooker CP-94ETX Instructions Pour L'installation Et L'emploi

GB IE
IT CH

Level button

The "level button" defines the level of the water in the tank: high level for cooking the pasta, low level for steaming.
Important: keep clean the probe level

TIME- OUT

After discovering the level probe, the micro controller triggers an internal timer relative to the duration of this phase. If
(continuous) loading takes longer than 350 seconds, the system blocks the functions of the device and the alarm is
signalled by the steady red light.
To reset the alarm condition, after removing the fault that caused the intervention (broken or disconnected level probes,
problems with the water supply, drain valve open...), the system must be turned OFF/ON.

CLEANING AND MAINTENANCE

Attention! During cleaning, do not wash the external parts of the appliance with direct sprays of water or with
high pressure.
After every use, clean the appliance thoroughly. Daily cleaning after switching off the appliance ensures the perfect
functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply. The parts in steel must be washed with hot water
and neutral detergent, then rinsed thoroughly in order to eliminate all traces of detergent; after which, dried with a dry
cloth. Do not use abrasive or corrosive detergents.
PROCEDURE TO FOLLOW IF THE APPLIANCE IS NOT GOING TO BE USED FOR
SOME TIME
Clean and dry the appliance carefully according to the instructions. Disconnect the power supply.

PROCEDURE TO FOLLOW IN THE EVENT OF A BREAKDOWN

In the event of breakdown, turn off the appliance, disconnect the power supply by using the device situated above the
appliance and notify the after sales service.

MAINTENANCE (ONLY FOR QUALIFIED PERSONNEL)

Any kind of maintenance must only be done by qualified personnel. Before carrying out maintenance, remove the plug
or switch off the switch above the appliance. Empty the tub when it is full.

ACCESSIBILITY

To get to the junction box, remove the back of the appliance. The control elements are reached from the front control
panel; unscrew the cap of the Water filling Tap, unscrew the fixing screws from the control panel and remove it
26