Instructions For Use; Water Supply Characteristics; Turning On; Emptying The Tub - Lotus cooker CP-94ETX Instructions Pour L'installation Et L'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Attention! Use the appliance only under surveillance.

- Never start up the appliance without water.

With pasta cookers it is possible to cook pasta, vegetables, rice, eggs, legumes, etc.

The system must be connected to a drinking water supply with the following characteristics. Failure to do so

automatically invalidates the guarantee

Total hardness: 0,5 to 5°F to prevent the build-up of lime-scale

Pressure: 50 to 250 kPa (0,5-2,5 bar).

Chlorine ion concentration (Cl-): not more than 10 ppm (acceptable value) to avoid damaging the internal steel

elements

pH: over 7

Electrical conductivity: 50 to 2000 µS/cm (20°C)

Check that the water drainage tap is turned off.

1) When powering the device, the red light flashes briefly for about ½ second.

2) In the absence of water in the tank the red light keeps flashing.

3a) Turn on the tap to load the tank to the desired level, which must be higher than the minimum level probe and do not

exceed the maximum level, which is marked on the tank by the symbol (--)

3b) In models with automatic load, the water starts loading and you can select the desired level by pressing the button

with symbol (level button)

4) Switch on the main switch installed above the appliance. Turn the control knob corresponding to the hotplate from

position "0" to the degree of coking desired, between 1 and 4.

The white light shows that the heating element is working

To turn off the appliance, turn the knob into position "O".

To carry out this operation, it is necessary to open the outlet tap (lever in vertical position) which can only be reached

through the cabinet door situated below the appliance.

If the probe does not detect the presence of water in the tank for more than 15 sec. the system disables the heating

element: the alarm is indicated by a flashing red light

When the probe returns to detect the presence of water, the heating element is activated and the red light is turned off

NOTE: the filling phase is monitored by the system through the TIME-OUT.

PASTA COOKER WITH AUTOMATIC LOADING

If the probe does not detect the presence of water, the system will restore the correct level and after 15 sec. it will

disable the heating element: the alarm is indicated by a flashing red light

When the probe returns to detect the presence of water, the heating element is activated immediately and after 3 sec. the

automatic refilling is stopped

NOTE: the filling phase is monitored by the system through the TIME-OUT.

Slow refilling button

When the "slow refilling button" is active the system will fill the tank slowly so as to eliminate any foaming.