Genesis GLSDF36A Manuel D'utilisation page 3

WARNiNG:
instructions before using this equipment. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal injury.
TOOL USE AND CARE
• Keep your work area clean and well lit . Cluttered benches and dark areas invite
accidents.
• Do not operate power tools in explosive atmospheres , s
flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes.
• Keep bystanders, children, and visitors away while operating a power
tool .
Distractions can cause you to lose control.
• Power tool plugs must match the outlet.
adapter plugs in any earthed (grounded) power tools. Double insulated tools are equipped with a polarized plug
(one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a polarized outlet. Do
not change the plug in any way. Double insulation eliminates the need for the three wire grounded power cord and
grounded power supply system.
• Do not expose power tools to rain or wet conditions.
increase the risk of electric shock.
• Do not abuse the cord.
cord away from heat, oil, sharp edges or moving parts. Damaged cords increase the risk of electric shock.
• When operating a power tool outside, use an extension cord suitable for
outdoor use.
These cords are rated for outdoor use and reduce the risk of electric shock.
• Do not use AC only rated tools with a DC power supply.
work. the electrical components of the AC rated tool are likely to fail and rate a hazard to the operator.
• Stay alert
, watch what you are doing and use common sense when operating a power tool. Do not use tool
while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power
tools may result in serious personal injury.
• Use safety equipment
safety shoes, hard hat, or hearing protection for appropriate conditions will reduce personal injuries.
• Dress properly.
moving parts. Loose clothes, jewelry or long hair can be caught in moving parts. Air vents may cover moving parts
and should be avoided.
• Do not use a ladder or unstable support.
control of the tool in unexpected situations.
• Keep tool handles dry, clean and free from oil and grease.
safely control the tool.
• Secure the workpiece.
holding the work piece by hand or against your body is unstable and may lead to loss of control.
ReAD and understand all warnings, cautions and operating
SAVe THeSe INSTRUCTIoNS
Never use the cord for carrying, pulling or unplugging the power tool. Keep
. Always wear eye protection. Safety equipment such as dust mask, non-skid
Do not wear loose clothing or jewelry. Keep your hair, clothing and gloves away from
use clamp or other practical way to hold the work piece to a stable platform.
uch as in the presence of
Never modify the plug in any way. Do not use any
Water entering a power tool will
While the tool may appear to
Stable footing on a solid surface enables better
Slippery handles cannot
3