Kenmore 137631400 A Instructions D'installation page 23

Reattaching the door
1. Holding the door in both hands, squarely insert the "T"
post on the back of the hinge into the "T" slot on the
front panel and lower it to align the mounting holes.
"T" POST ON
DOOR HINGE
2. While supporting the door, install the upper pan head
screw fi rst and then the lower one.
NOTE
Correctly installed hinge screws will press hinge fl ush to
front panel. Any gap between hinge and front panel will
cause misalignment of strike to latch.
3. Close the door and test operation of hinge, strike and
latch.
"T" SLOT IN
FRONT PANEL
23
Reversing Door Swing