Setting The Temperature; Wine Storage; Shelf Instructions - Danby Designer DWC106A1BPDD Guide D'utilisation Et Soins De Propriètaire

SETTING THE
Important: In the event of a power failure, wait 3 to 5 minutes before restarting.
TEMPERATURE
• To switch the display between the Fahrenheit (°F) and Celsius (°C) scale, depress the 'UP' and 'DOWN'
control buttons simultaneously for approximately five (5) seconds.
• The temperature range can be set as low as 43°F (6°C) or as high as 57°F (14°C) to suit your specific wine
storage requirements. Each depression of the 'UP' or 'DOWN' buttons will allow you to adjust the
temperature in 1° increments within the aforementioned range.
• You may view your 'set' temperature at any time by briefly depressing either the 'UP' or 'DOWN' button.

WINE STORAGE

To accommodate 75 bottles it will be necessary for
you to stock your wine cooler in the following way:
• The first shelf holds 6 bottles arranged as per Fig. 3,
with an additional bottle stacked on either side of the
controls, for a total of 8 bottles per the first shelf.
• The second shelf holds 6 bottles arranged as per Fig.
3.
• The third shelf holds 11 bottles when stacked as per
Fig. 4; 6 bottles across the shelf, with 5 bottles
SHELF
INSTRUCTIONS
To Remove a Shelf:
To remove a shelf from its locked position, tilt the shelf as shown in Fig. 6 and pull
outward.
To Reinstall a Shelf:
To reinstall, ensure the shelf is resting securely on the support brackets and push the
shelf inward until it locks in place.
OPERATING INTRUCTIONS (cont'd)
The DWC106A1BPDD has a maximum* capactiy of 75 (750mL) bottles of wine.
* when stocked as per the below instructions.
Fig. 3
IMPORTANT!
Do not cover any part of the shelves with aluminum foil or any other material that
will prevent adequate air circulation within the cabinet.
stacked alternately on top.
• The fourth and fifth shelves hold 6 bottles with one
bottle stored horizontally behind, as in Fig. 5.
• The sixth through ninth shelves hold 6 bottles
arranged as per Fig. 3
• The bottom of your wine cooler contains a 2-tier
wooden rack which accommodates 6 bottles per rack,
arranged as per Fig. 3; this allows for a total of 75
(750mL) bottles of wine.
Fig. 4
5
Fig. 5
Fig. 6