Calesco LMF Touch Mode D'emploi page 4

ADJUSTING THE CONTROL DEVICE
When the user touches the lock
the display will light up, showing the correct
water temperature. In order to change
any settings, the lock
pressed and held for a few seconds until
the menu is shown (Fig 2A)
TEMPERATURE (FIG
To change the temperature, press the
button until the square surrounds the icon
(Fig 2A)
2
FIG A
Now press the lock
the temperature with the
save the temperature settings push the
lock button.
2
FIG B
SETTING THE CLOCK (FIG
For the timer to work correctly, it is
important to set the clock to the correct time.
To set the clock, press the
square surrounds the icon (Fig 2C).
2
FIG C
Now press the lock
the time using the
hours first then minutes. To save the time
settings push the lock
2
FIG D
IMPORTANT!
If the control device is unplugged, you
will need to set the time again. It will not
remember your last settings.
button
button must be
2 2
A and B)
button and adjust
buttons. To
2 2
C & D)
button until the
button to change
button. Choose
button.
2
TIMER ON (FIG E &
To set the start time for heating the
element, press the
square surrounds the icon (Fig 2E).
2
FIG E
Now press the lock
the time with the
start time settings push the lock
2
FIG F
2
TIMER OFF (FIG G &
To set the end time for heating the element,
press the button until the square
surrounds the icon (Fig 2G).
2
FIG G
Now press the lock
the time with the
end time settings push the lock
2
FIG H
TIMER DEACTIVATED MODE
The timer is deactivated if both timers ON and
OFF are set to hour 0. Minutes will be ignored.
ERROR CODES (FIG 2I & 2J)
If the display shows this symbol it means the
heater is not connected or the temperature
sensor might be broken. Make sure the
connector is pushed all the way into the box.
2
FIG I
This symbol indicates the AC power plug
should be rotated in the wall socket to get
the best LMF performance.
2
FIG J
2
F)
button until the
button and adjust
buttons. To save the
button.
2
H)
button and adjust
buttons. To save the
button.
4