Velleman ARCHITECTURAL CITY COLOR 1200 Mode D'emploi page 4

 All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
 Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
lamp explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
 Mechanical wear and LEDs are not covered by warranty.
 A qualified technician shall install and service this device.
 Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
 This device is designed for professional use on stage, in discos, theatres, etc. The device shall only be used
with an alternating current of 110-250 V~, 50/60 Hz.
 Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
 Use the original packaging if the device is to be transported.
 Keep this manual for future reference.
4. Features
The CITY COLOR 1200 is a high-powered LED light used for a decorative and colourful lighting of buildings,
clubs, hotels, stages, parks, plazas, commercial building facades, art galleries and more.
The CITY COLOR light series features RGBW LEDs and supports the entire colour spectrum, even custom-
programmed colours.
 delivered in a flight-case for safe and easy transportation
 die-cast aluminium housing
 DMX control:
4 channels: RGBW
o
7 channels: RGBW, dimmer, colour mixing, shutter
o
 multiple dimming modes for smooth colour mixing
 pre-programmed stand-alone effects
5. Installation
Choose a suitable mounting spot. Connect the power cord to the mains and switch on. Switch off and
disconnect after use.
General Guidelines
 Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
 The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
 The installation must always be secured with a secondary attachment e.g. a safety cable.
 Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
 Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
 Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in injuries.
 For truss mounting, use appropriate clamps and brackets.
 Make sure there is no flammable material within a 0.5 m radius of the device.
 Have a qualified electrician carry out the electric connection.
 Connect the device to the mains with the power plug. All devices must be powered directly off a grounded
switched circuit and cannot be run off a rheostat or dimmer circuit, even if the rheostat or dimmer channel
is used solely for 0 % to 100 % switching.
 The device has a power output to supply power to another device. When connecting several devices in a
daisy chain via this output, make sure that the total current does not exceed the power line's nominal
current. Use power cables with an adequate section.
 The installation has to be approved by an expert before the device is taken into service.
V. 01 – 24/03/2015
VDPLOW1208
4 ©Velleman nv