LENCO Classic Phono TT-34 Mode D'emploi page 6

PREPARATION FOR USE
UNPACKING AND SET UP
•
Carefully remove the unit from the display carton and remove all packing material from
the unit.
•
Unwind the AC power plug and extend it to its full length.
•
Place the unit on a stable, level surface, convenient to an AC outlet, out of direct
sunlight, and away from source of excess heat, dust, moisture, humidity or strong
magnetic field.
•
Connect the plug to your AC outlet.
•
Raise the lid to expose the phonograph. The phonograph has been secured for
shipment with a transit screw.
•
Use a coin or screwdriver to turn the transit screw clockwise. This will allow the
turntable to "float".
TRANSIT SCREW
•
Remove the opaque while plastic stylus cover from the phonograph stylus by sliding it
in the direction of the arrow.
Discard the stylus cover.
•
Remove the twist-tie that was used to secure the tone arm during shipment.
•
Release the tone arm lock lever.
•
Connect the plug to your AC outlet.
6