Filling The Tank; Use - TECHEATEASY FORMULA @SPRESSO Mode D'emploi

START UP
Remove the machine from the packaging and place it on a stable surface
that can sustain the weight and near a suitable electrical socket.
Warning
Keep the packaging and all its parts for future transport. The warranty is
void without the original packaging.
Warning
Leave at least 10 cm around the machine on all sides.
Do not cover the machine with clothes or protective clothes.

FILLING THE TANK

Warning
The operations described below must be performed with
the machine disconnected from the electrical network.
A
- Remove the cover of the
- Press stop (B);
- Remove the water tank
- Rinse the water tank (C) thoroughly with running water and externally
- fill it with approximately 2 litres of drinking water, preferably with a
- Place the water tank back in its compartment carefully placing the tubes
- replace the cover of the water tank compartment.
Do not exceed the water tank's capacity.
Make sure that the outside of the tank is not wet. If necessary, dry it
with a cloth.
B
water tank compartment (A);
(C) from its compartment,
meanwhile the two aspiration
and water recovery tubes (D)
will come out of the water tank;
dry it;
low limescale content (less than 25° f - French degrees);
back in its position, without making them too tense so that they do not
hinder the vertical movement of the water tank;
Warning
15
D
C
u s e r' s Ma n ua l
EN