Connection To The Mains - TECHEATEASY Globo Mode D'emploi

C
D
- Lift the water tank compartment cover (A);
- Remove the two water suction pipes (B) from the mouth of the water
tank (C) and extract it from its seat;
- rinse it with abundant running water and dry it on the outside;
- fill it with approximately 2 litres of drinking water, preferably with a low
limescale content (less than 25° f - French degrees);
- put the water tank back in its seat;
- fit the limescale filter (D) into the longer hose (B);
- reinsert the pipes previously removed in the holes provided in the
tank;
- replace the cover of the water tank compartment;
Warning
Do not exceed the water tank's capacity.
Make sure that the outside of the tank is not wet. If necessary, dry it
with a cloth.

CONNECTION TO THE MAINS

A
Things To checK BeFore connecTing
Warning
The power supply voltage of the machine may not be modified by the
user. Before connecting to the mains, check that:
the mains voltage corresponds to the power supply voltage of the
machine, indicated on the identification plate on the rear of the
B
machine;
- that the plug of the machine's power cable connection fits into the
socket;
- that the socket or the electrical network is connected to a device
protecting against indirect contact (circuit breaker) with a fault current
I∆n not greater than 20mA;
- the outlet is efficiently earthed and controlled;
- the power cable is undamaged.
prohiBiTions
Warning
- Do not use extension cords of any kind to connect the machine to the
mains.
- Do not use reduction devices to connect the plug to the outlet.
- Do not use multiple connection devices ("flappers" or triple outlets) to
connect the machine to the outlet.
15
EN
USEr'S MANUAL