Sanyo PLC-SE10 Mode D'emploi page 44

CONFIGURATIONS OF THE TERMINALS
COMPUTER INPUT / MONITOR OUT TERMINAL (ANALOG)
Terminal : HDB15-PIN
Connect the display output/input terminal of the computer to these terminal with the VGA Cable (supplied). When
connecting the Macintosh computer, MAC Adapter (not supplied) is required.
Pin Configuration
5 4 3 2 1
10 9 8 7
15
14 13 12 11
CONTROL PORT CONNECTOR
Terminal : Mini DIN 8-PIN
Connect control port (PS/2, Serial or ADB port) on your computer to this connector with Control Cable.
(Control Cable for PS/2 port is supplied, and Control Cables for Serial port and ADB port are not supplied.)
Pin Configuration
8 7 6
5 4 3
2 1
USB CONNECTOR (Series B)
Connect USB port terminal on your computer or peripheral equipment to this connector with USB Cable (not supplied).
Pin Configuration
2 1
3 4
1 Red Input
2 Green Input
3 Blue Input
4 Sense 2
6
5 Ground (Horiz.sync.)
6 Ground (Red)
7 Ground (Green)
8 Ground (Blue)
PS/2
1 -----
2 CLK
3 DATA
4 GND
5 -----
6 -----
7 GND
8 -----
1 Vcc
2 - Data
3 + Data
4 Ground
9 +5V Power
10 Ground (Vert.sync.)
11 Sense 0
12 DDC Data
13 Horiz. sync.
14 Vert. sync.
15 DDC Clock
Serial ADB
R X D -----
----- ADB
----- -----
GND GND
RTS / CTS -----
T X D -----
GND -----
GND GND
APPENDIX
43