Appendix; Operating Wireless Mouse - Sanyo PLC-SE10 Mode D'emploi

APPENDIX

Remote Control Unit is not only able to operate this projector but also usable as a wireless mouse for most Personal
Computers. POINT buttons and two CLICK buttons are used for wireless mouse operation.
This Wireless Mouse function is available only when PC mouse pointer is displayed on a projected screen. When ON-
SCREEN MENU or any message / dialog box is displayed on the screen instead of PC mouse pointer, this Wireless Mouse
function cannot be used.
To use Remote Control Unit as Wireless Mouse for a Personal Computer, installation of the mouse driver (not supplied) is
required. Make sure that the mouse driver is properly installed in your computer. And make sure that the mouse port (or
USB port) of a Personal Computer is activated.
1 Connect the mouse port (or USB port) of your computer to
Control Port (or USB connector) of this projector with Control
Cable (or USB cable). (Refer to page 11, 12 for connection.)
2
Turn the projector on first, and then turn on your computer.
When the computer is switched on first, Wireless Mouse may not
work properly.
When controlling a PC mouse pointer, operate Wireless Mouse with POINT button, SELECT button, and RIGHT CLICK
button on Remote Control Unit.
POINT button
Used to move PC mouse pointer.
corresponding with the direction you are pressing.
SELECT (LEFT CLICK) button
This button has the same function as the left button in a PC mouse.
RIGHT CLICK button
This button has the same function as the right button in a PC mouse.
This button is not available for controlling this projector.

OPERATING WIRELESS MOUSE

INSTALLATION
OPERATING WIRELESS MOUSE
The pointer is moved
Note : When your computer has no mouse
port, connect Serial Port of your
computer to Control Port of the
projector with Control Cable for Serial
Port (not supplied).
POINT button (Move the pointer)
SELECT button RIGHT CLICK button
(left button of the (right button of the mouse)
mouse)
37