Installation Site; Use - SATA clean RCS Mode D'emploi

Technical status
■ Check the functions of SATA clean RCS and check for any leaks every
time before they are used.
■ Never start using SATA clean RCS when damaged or when parts are
missing.
■ Check SATA clean RCS every time before use and repair if necessary.
■ Stop using SATA clean RCS immediately if they are damaged and dis-
connect from the compressed air circuit.
■ Never make any unauthorised modifications or technical changes to SATA
clean RCS.
Cleaning agents
■ Never use acidic or alkaline cleaning agents or cleaning agents containing
petrol.
■ Never use cleaning agents based on halogenated hydrocarbons.
Connected components
■ Only use original SATA spare parts and accessories.
■ The connected hoses and lines must reliably withstand the thermal,
chemical and mechanical loads expected when using SATA clean RCS.
■ When pressurised hoses work loose, their whip-like movements can
cause injuries. Always vent the hoses completely before they are loos-
ened.

Installation site

■ When installing SATA clean RCS outside the spray booth for operations
using cleaning solutions containing solvents, always comply with the
following:
■ Ex-zone 1 applies up to a radius of 3 m around the unit.
■ Ex-zone 2 applies in a range from 3 m to 5 m around the unit.
■ Never use SATA clean RCS in the vicinity of ignition sources, such
as naked flames, burning cigarettes or non-explosion-proof electrical
equipment.
General
■ Comply with the local regulations for safety, accident prevention, occu-
pational health and safety and environmental protection.
■ Adhere to BGR 500 accident prevention regulations.

3. Use

Intended Use
SATA clean RCS are used for rapid, convenient interim cleaning of spray
Operating Instructions SATA RCS
EN
97