Final Installation - Acksys WLg-SWITCH Guide D'installation Rapide

Setup the IP addresses according to the illustration above.
From each PC, run a command prompt and execute the ping command to
verify the link.
From PC 1 : type ping 192.168.1.2, verify the answer returned by PC2
« Answer from 192.168.1.2 ... »
From PC 2 : type ping 192.168.1.1, verify the answer returned by PC1
« Answer from 192.168.1.1 ... »
Notice: The Diag & Wlan Tx/Rx LED are flashing while the bridge is not
connected to the AP. WLan Tx/Rx LED is flashing blue for WLAN Tx or Rx
activity.
• Install the device
The WLg-SWITCH supports temperatures from -13°F (-25°C) to +158°F
(+70°C), and is housed in an IP30 protected enclosure. It should be installed
preferably in a well-ventilated area, and kept away from dust and water
spraying. Mounting the product on the DIN rail is detailed in page 9.
• Modifying device's parameters
Via the integrated web management interface, set the following main
parameters:
- The operating mode: AP mode with or without WDS, Infrastructure
bridge mode, ad-hoc bridge mode
- Wifi security parameters (WEP, WPA, WPA-PSK, WPA2, WPA2-PSK,
MAC address filtering, SSID broadcast or not)
- Wifi parameters: 802.11 mode, radio channel (take care about
legislation), SSID
- Configuration of alarm conditions
- VLAN configuration
All 8 leds indicator are OFF
- Verify the power supply.
- Verify the cabling and connectors
Remote WiFi clients cannot connect to the AP
- Make sure that the client's Wireless parameters match the parameters
defined in the AP (SSID case sensitive, 802.11 mode, radio channel,
security). If possible, temporarily disable all securities and encryption
settings.
- Check the radio conditions: distance between equipments, placement
and orientation, radio waves obstruction, interferences on the radio
channel...
- Try another radio channel.
WLAN and DIAG2 LEDs are flashing in bridge mode
- This means that the bridge is out of range of the AP, or the wireless
parameters in the products don't match the parameters declared in the
Access Point (verify SSID, Security parameters). Try to move the device,
or change antenna orientation.
"ACKSYS NDM" doesn't find your device
- ACKSYS NDM only scans the local network. Devices located behind a
gateway are not seen.
- If you use a firewall on your P.C, verify it doesn't block UDP port 17784
and SNMP port (UDP port 161 by default).
How to restore factory settings
- If the built-in web-based interface is reachable, you can use your
browser to restore factory settings.
- Otherwise, press the reset button for at least 2 seconds while the unit is
powered on, using, for example, a paper clip.

FINAL INSTALLATION

TROUBLESHOOTING
-5-