Settings - Teac CD-P800NT Mode D'emploi

Follow the procedures below to open the menu and change

settings.

1
Press the MENU button.
o You can also press and hold the MENU/ENTER
(.//) dial on the main unit to do this.
2
Use the direction (k/j) buttons to select
the setting you want to change.
Press a direction (k/j) button repeatedly to cycle
through the settings in the following order.
MP3 Setting
Update
NET Setting
MFE (Music Frequency Enhancement)
ASb (Auto Standby)
o "MFE" only appears when the source is set to USB/
NET.
o "MP3 setting" only appears when the source is set
to CD.
o The setting shown first depends on the current
source.
Settings
You can also turn the MENU/ENTER (.//) dial
on the main unit to do this.
3
Press the ENTER button.
You can also press the MENU/ENTER (.//) dial
on the main unit to do this.
After opening "MP3 setting" or "NET Setting", repeat
2
steps and
o You must wait at least one minute after turning the
unit on to select and change the "NET Setting" and
"Update" items.
4
Use the skip (.//) buttons to change
setting values.
o You can also turn the MENU/ENTER (.//)
dial on the main unit to do this.
Continued on the next page
1
to make a selection in the submenu.
e
45 45