Operation - Sub Pro Série Guide D'utilisation Et D'entretien

Storage
Refrigerator Storage
PULL-OUT SHELF
The bottom shelf pulls out for easy access to condiments
and other items commonly stored on door shelves. Adjust-
able rails keep items snugly in place. To adjust, pull the rail
up and rotate. Refer to the illustration below.
CRISPER LID
To remove the crisper lid assembly, pull the upper refrig-
erator drawer all the way out, raise the front edge of the
crisper lid up, and pull out from the back. Refer to the
illustration below.
DRAWER DIVIDERS
Long dividers run the full depth of the drawer, with shorter
dividers that connect to the long dividers to compartmen-
talize the drawer.
To remove the short dividers, lift up and out. The long
dividers cannot be removed.
Pull-out shelf Crisper lid (48" model shown)
6 | English
Freezer Storage
STAINLESS STEEL SHELVES
For 1219 mm models, to remove or adjust a shelf, tilt up,
then lift up and out. To install, insert the shelf in the tracks
along the back wall, then lower the front until it locks into
position.
ICE CONTAINER
To remove the ice container, pull the drawer out to full-
extension, then lift the container up and out.
Storage Drawers
Refrigerator and freezer storage drawers are removable for
cleaning. An automatic stop is built in to prevent the draw-
ers from coming all the way out unintentionally.
To remove, pull the drawer out to full-extension. Apply
forward pressure to the front of the drawer slide, and pull
up and back on the drawer handle. Refer to the illustration
below.
DRAWER
SLIDE
Storage drawer removal

Operation

Air Purification System
Many fresh foods emit ethylene gas, a naturally-occurring
compound that hastens food ripening and spoilage. The
air purification cartridge has been factory installed and is
located inside the refrigerator on the back wall.
To initiate air purification, touch , then touch
The cartridge will last approximately one year. "Change Air
Purifier" will appear on the display when the cartridge
needs to be replaced. Touch "Snooze" to delay the reminder
for 24 hours or until cartridge can be replaced. Touch
"Refresh" to reset the life indicator to 100% once the car-
tridge is replaced.
AIR PURIFICATION CARTRIDGE REPLACEMENT
1 To access the air purification cartridge, grasp the out-
side cover from the bottom and rotate upward. Refer to
the illustration below.
.
Grasp the black cover from the top and rotate down-
2
ward. The cartridge will pop out and can be removed.
3 Remove the new cartridge from packaging and insert
with the connector pointing downward.
4 Once in position, close the black cover. Then rotate the
outside cover downward until it closes against the back
wall.
5 Once the cartridge has been replaced, follow the
instructions on the display. The cartridge life cycle will
reset for approximately one year.
Air purification cartridge