Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.
OPERATING INSTRUCTIONS
4.1
USING The INC-7A-OBD MEMORY SAVER
Use the INC-7A-Obd Memory Saver to save the vehicle's on-board
diagnostic computer settings (radio programs, diagnostic codes, etc.)
while battery is disconnected from vehicle during repair or maintenance.
To use the INC-7A-OBD:
1.
Make sure that the Memory Saver's internal battery is fully
charged. See lEd INdICATORS section.
2.
Connect the Memory Saver's Obd connector to the vehicle's
Obd connector. Make sure that the connector is fully engaged.
3.
disconnect the vehicle's battery cables.
The vehicle's electrical system is receiving power from the Memo-
ry Saver through the Obd connection. Therefore, the vehicle's
battery connectors will still conduct electricity and should be
covered with an insulator to prevent the connectors from touching
metal or each other and causing a short circuit.
4.2
POWERING A 12V DC DEVICE
The INC-7A-Obd is a power source for all 12v dC accessories that are
equipped with a 12V accessory plug. Use it for power outages and fishing
or camping trips. Estimated usage time is listed in the chart below.
Make sure the device to be powered is OFF before inserting the 12v dC
accessory plug into the 12v dC accessory outlet.
1.
Open the protective cover of the dC power outlet on the side of
the INC-7A-Obd.
2.
Plug the 12v dC device into the dC power outlet, and turn the
12V DC device on (if required).
3.
If the 12v dC device draws more than 15A or has a short
circuit, the internal circuit breaker of the INC-7A-Obd will trip
and disconnect the power to the device. disconnect the 12v dC
device. The breaker will automatically reset after an overload
occurs.
battery. Extended operation of a 12V DC device may result in excessive
battery drain. Recharge immediately after unplugging the 12v dC device.
when working with the vehicle's battery, review all
of the battery manufacturer's and vehicle manu-
facturer's safety instructions, warnings and direc-
tives regarding battery disconnection, removal and
replacement.
The dC power outlet is wired directly to the internal
5
•
•
Publicité
Table des Matières
