Husqvarna PP 492 Manuel D'utilisation page 12

4. Push the "OK" button to get access to the main
menu.
5. Find the "SETTINGS" menu with the arrow buttons
and then push the "OK" button.
>MENU
DRIVE CHOICES
CALIBRATE ARM
SET BLADE DIAM.
[800 mm]
SETTINGS
6. Find "PAIR RADIO" with the arrow buttons and then
push the "OK" button.
>>SETTINGS
TIME & DATE
[20:51 2010-01-12]
LANGUAGE
[ENGLISH]
SET UNITS
[METRIC]
PAIR RADIO
Note: A message on the display tells if the pairing
operation was done or not. If you cannot do a pairing
operation between the remote control and the power
Troubleshooting wall saw on page
pack unit, refer to
15 .
The power source for the product
To use full power output, the power pack unit must be
connected to a 32 A fuse. With a 16 A or a 25 A fuse the
available power output is lower. It is necessary to select
an applicable fuse in the remote control menu system.
At a lower voltage the available power output decreases
in a linear fall down to 80%. Refer to
page 17 for more information.
967 - 001 - 04.02.2020
OK
ON/OFF
0
20 DEC 20:55
20 DEC 20:55
Technical data on
Gasoline generator as a power source
CAUTION: A generator that supplies more
input voltage than specified in the voltage
range can cause damage to the power pack
unit.
A generator that operates on gasoline can be used as a
power source if it can supply sufficient power. Refer to
Technical data on page 17 for typical generator
operation conditions. The generator must be grounded
to prevent damage to the power pack unit.
To connect a power source to the Power pack
CAUTION: Do not connect the product to a
power source without an applicable fuse.
1. Connect the power cord from the power source to
the electric socket on the product.
2. Use the remote control to select the correct fuse. In
the menu system, select "DRIVE CHOICES" and
then "SET FUSE".
3. Select the correct fuse.
>>>SET FUSE
16A
25A
32A
Other software adjustments
Do the adjustments that follow before you operate the
product:
Menu system overview on page 8 for
Note: Refer to
more information.
• Set time and date. Select the "SETTINGS" menu
and then the "TIME & DATE".
• Set the correct display language. Select the
"SETTINGS" menu and then "LANGUAGE".
20 DEC 20:55
11