Daily Use - Zanussi ZOP27901 Notice D'utilisation

Refer to "Care and cleaning" chapter.
Clean the appliance before first use.
Put the accessories back to their initial position.
SETTING THE TIME
After the first connection to the mains, all symbols
in the display are on for some seconds. For the
subsequent few seconds the display shows the
software version.
After the software version goes off, the display
shows and "12:00". "12" flashes.
1. Press or to set the current hour.
2. Press to confirm. This is necessary only
when you set the time for the first time. Later
the new time will be saved automatically after 5
seconds.
The display shows
flashes.
3. Press or to set the current minutes.
4. Press to confirm. This is necessary only
when you set the time for the first time. Later

DAILY USE

WARNING! Refer to Safety chapters.
ACTIVATING AND DEACTIVATING THE
APPLIANCE
It depends on the model if your
appliance has knob symbols,
indicators or lamps:
• The indicator comes on when the
oven heats up.
• The lamp comes on when the
appliance operates.
• The symbol shows whether the
knob controls the oven functions or
the temperature.
6
and the set hour. "00"
the new time will be saved automatically after 5
seconds.
The display shows the new time.
CHANGING THE TIME
You can change the time of day only if the oven is
off.
Press again and again until the indicator for the
time of day flashes in the display.
To set a new time, refer to "Setting the time".
PREHEATING
Preheat the empty appliance to burn off the
remaining grease.
1. Set the function
temperature.
2. Let the appliance operate for 1 hour.
3. Set the function
temperature.
4. Let the appliance operate for 15 minutes.
Accessories can become hotter than usual. The
appliance can emit an odour and smoke. This is
normal. Make sure that the airflow in the room is
sufficient.
1. Turn the knob for the oven functions to select
an oven function.
2. Turn the knob for the temperature to select a
temperature.
3. To deactivate the appliance turn the knobs for
the oven functions and temperature to the off
position.
and the maximum
and set the maximum