Table des Matières
Publicité
FCC COMPLIANCE STATEMENT
CAUTION: Changes or modifications not expressly approved by
Digital Security Controls could void your authority to use this equip-
ment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the in-
structions, may cause harmful interference to radio communications. How-
ever, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or tel-
evision reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Re-orient the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult a dealer or experienced radio/television technician for help.
The user may find the following booklet prepared by the FCC useful: "How
to Identify and Resolve Radio/Television Interference Problems". This book-
let is available from the U.S. Government Printing Office, Washington D.C.
20402, Stock # 004-000-00345-4.
IMPORTANT INFORMATION
This equipment complies with Part 68 of the FCC Rules and, if the product
was approved July 23, 2001 or later, the requirements adopted by the ACTA.
On the top side of this equipment is a label that contains, among other infor-
mation, a product identifier. If requested, this number must be provided to the
Telephone Company.
Product Identifier:
US:F53AL01B9057
USOC Jack:
RJ-31X
Telephone Connection Requirements
A plug and jack used to connect this equipment to the premises wiring and
telephone network must comply with the applicable FCC Part 68 rules and
requirements adopted by the ACTA. A compliant telephone cord and modu-
lar plug is provided with this product. It is designed to be connected to a com-
patible modular jack that is also compliant. See installation instructions for
details.
Ringer Equivalence Number (REN)
The REN is used to determine the number of devices that may be connected
to a telephone line. Excessive RENs on a telephone line may result in the de-
vices not ringing in response to an incoming call. In most but not all areas,
the sum of RENs should not exceed five (5.0). To be certain of the number
of devices that may be connected to a line, as determined by the total RENs,
contact the local Telephone Company. For products approved after July 23,
2001, the REN for this product is part of the product identifier that has the
format US: AAAEQ##TXXXX. The digits represented by ## are the REN
without a decimal point (e.g., 03 is a REN of 0.3). For earlier products, the
REN is separately shown on the label. REN = 0.1B
Incidence of Harm
If this equipment (SCW9055/SCW9057) causes harm to the telephone net-
work, the telephone company will notify you in advance that temporary dis-
continuance of service may be required. But if advance notice is not practical,
the Telephone Company will notify the customer as soon as possible. Also,
you will be advised of your right to file a complaint with the FCC if you be-
lieve it is necessary.
Changes in Telephone Company Equipment or Facilities
The Telephone Company may make changes in its facilities, equipment, op-
erations or procedures that could affect the operation of the equipment. If this
happens the Telephone Company will provide advance notice in order for
you to make necessary modifications to maintain uninterrupted service.
Equipment Maintenance Facility
If trouble is experienced with this equipment (SCW9055/SCW9057) for re-
pair or warranty information, contact the facility indicated below. If the
equipment is causing harm to the telephone network, the Telephone Compa-
This publication covers the following models:
• SCW9055-433/868
• SCW9057-433/868
• SCW9055D-433/868
• SCW9057D-433/868
• SCW9055I-433/868
NOTE: The 868 MHz models are not UL/ULC listed.
NOTE: Only these models shall be used with UL/ULC listed systems: SCW9055-433,
SCW9057-433, SCW9055G-433, SCW9057G-433, WT5500-433, WT5500P-433, WT4901,
WT4911, WT4989 and PT4.
• SCW9057I-433/868
• SCW9055G-433/868
• SCW9057G-433/868
• WT5500-433/868
• WT5500P-433/868
ny may request that you disconnect the equipment until the problem is
solved. This equipment is of a type that is not intended to be repaired by the
end user.
DSC c/o APL Logistics 757 Douglas Hill Rd., Lithia Springs, GA 30122
Additional Information
Connection to party line service is subject to state tariffs. Contact the state
public utility commission, public service commission or corporation com-
mission for information.
Alarm dialling equipment must be able to seize the telephone line and place
a call in an emergency situation. It must be able to do this even if other equip-
ment (telephone, answering system, computer modem, etc.) already has the
telephone line in use. To do so, alarm dialling equipment must be connected
to a properly installed RJ-31X jack that is electrically in series with and ahead
of all other equipment attached to the same telephone line. Proper installation
is depicted in the figure below. If you have any questions concerning these
instructions, you should consult your telephone company or a qualified in-
staller about installing the RJ-31X jack and alarm dialling equipment for you.
Customer Premises Equipment and Wiring
Net ork
Service
Provider's
R -31
Facilities
ack
Alarm Dialing
Equipment
Telephone
Line
Net ork
Demarcation
Point
Telephone
Ans ering
System
INDUSTRY CANADA STATEMENT
NOTICE: This product meets the applicable Industry Canada technical
specifications.
Le présent materiel est conforme aux specifications techniques applicables
d'Industrie Canada.
The Ringer Equivalence Number (REN) for this terminal equipment is 0.1.
L'indice d'équivalence de la sonnerie (IES) du présent matériel est de 0.1.
The Ringer Equivalence Number is an indication of the maximum number of
devices allowed to be connected to a telephone interface. The termination on an
interface may consist of any combination of devices subject only to the require-
ment that the sum of the RENs of all the devices does not exceed five.
L'indice d'équivalence de la sonnerie (IES) sert à indiquer le nombre maximal
de terminaux qui peuvent être raccordés à une interface téléphonique. La termi-
naison d'une interface peut consister en une combinaison quelconque de dis-
positifs, à la seule condition que la somme d'indices d'équivalence de la
sonnerie de tous les dispositifs n'excède pas 5.
The term 'IC:' before the radio certification number only signifies that Industry
Canada technical specifications were met.
Certification Number IC: 160A-9057 (models SCW9055-433/SCW9057-433)
Certification Number IC: 160A-9057G (models SCW9055(D)(G)(SM)-433/
SCW9057(D)(G)(SM)-433)
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil
numérique de la classe B est conforme à la norme NMB-003 du Canada.
The SCW9055(X)-433 and SCW9057(X)-433 have been investigated by UL
and ULC and found in compliance with the listing requirements for Residen-
tial Fire and Burglary applications in accordance with the following stand-
ards: UL985, UL1023, UL1635, ULC-S545 and ORD-C1023.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard
RSS (s). Le fonctionnement est soumis aux deux conditions suivantes: (1) cet
appareil ne peut pas provoquer d'interférences et (2) cet appareil doit accepter
toute interférence, y compris les interférences qui peuvent causer un mauvais
fonctionnement de l' appareil.
• WT4989
• WT8989
• WT4901
• WT8901
Computer
nused
R -11 ack
Telephone
nused
Fax Machine
R -11 ack
Telephone
• WT4911
• WT8911
• PT4
• PT8
Publicité
Table des Matières
