Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Limited One Year Warranty
T&S warrants to the original purchaser (other than
for purposes of resale) that such product is free from
defects in material and workmanship for a period of
one (1) year from the date of purchase. During this
one-year warranty period, if the product is found to
be defective, T&S shall, at its options, repair and/
or replace it. To obtain warranty service, products
must be returned to...
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other transpor-
tation charges of the product to T&S and the return
of repaired or replaced product to the purchaser are
the responsibility of the purchaser. Repair and/or
replacement shall be made within a reasonable time
after receipt by T&S of the returned product. This
warranty does not cover Items which have received
secondary finishing or have been altered or modi-
fied after purchase, or for defects caused by physi-
cal abuse to or misuse of the product, or shipment
of the products.
Any express warranty not provided herein, and
any remedy for Breach of Contract which might arise,
is hereby excluded and disclaimed. Any implied
warranties of merchantability or fitness for a particu-
lar purpose are limited to one year in duration. Under
no circumstances shall T&S be liable for loss of
use or any special consequential costs, expenses
or damages.
Some states do not allow limitations on how long
and implied warranty lasts or the exclusion or limi-
tation of incidental or consequential damages, so
the above limitations or exclusions may not apply
to you. Specific rights under this warranty and other
rights vary from state to state.
P/N: 098-006183-45 Rev.1
Date: 980805
Drawn: CW
Checked: MAB 10-16-98
Approved: MW 10-15-98
Installation and
Maintenance
Instructions
B-1070
Concealed
By-Pass Mixing Valve
Deutsch:
Installations- und
Wartungsanleitungen
Español:
la Instalación y las
Instrucciones de
Mantenimiento
Français:
les Instructions
d'Installation et
d'Entretien

Publicité

Table des Matières
loading

Sommaire des Matières pour T&S B-1070

  • Page 1 Any express warranty not provided herein, and any remedy for Breach of Contract which might arise, is hereby excluded and disclaimed. Any implied B-1070 Concealed warranties of merchantability or fitness for a particu- lar purpose are limited to one year in duration. Under no circumstances shall T&S be liable for loss of...
  • Page 2: Exploded View

    Exploded View Some items are listed for instructional purposes and may not be sold as separate parts.
  • Page 3 Part Number Guide Mixing Valve Assembly Asm, Concealed By-Pass Mixing Valve B-1030 Body, Valve Chamber Mix, 8" Set Screw, Escutcheon Flange Escutcheon Escutcheon Tube Asm, Spindle Eterna - Hot 005960-40 Handle, 4-Arm Kitchen 002521-45 Index Button, Blue - Cold 001660-45 Index Button, Red - Hot 001661-45 Screw, Lever Handle...
  • Page 4: General Instructions

    General Instructions Installation: 1. Shut off water supply and drain lines. Drill (2) two holes, approxi- mately 1-3/8” [34 cm] diameter in wall with 8” [20 cm] center to center. 8” [20 cm] 1/2” 1/2” 3/4” IPS supply supply supply line to l i n e l i n e...
  • Page 5: Instrucciones Generales

    Instrucciones Generales Instalación: 1. Cierre la fuente de agua y desagüe las tuberias. Perfore (2) dos huecos, aproximadamente de 1-3/8” [34 cm] de díametro en la pared con distancia de 8” [20 cm] de centro a centro. 8” [20 cm] 1/2”...
  • Page 6: Instructions Générales

    Instructions Générales Installation: 1. Fermer la réserve de l’eau et égoutter la tuyauterie. Percer deux (2) trous avec un diamètre environ 34 cm. avec 20cm. de centre à centre. 8” [20 cm] 1/2”tuyau 1/2”tuyau 3/4” tuyau qui fournir qui fournir qui fournir l’eau NPT l’eau NPT...
  • Page 7: Allgemeine Anleitungen

    Allgemeine Anleitungen Installation: 1. Wasserzulauf absperren und Leitungen entleeren. Zwei ungefähr 3,4 cm große Löcher mit einem Mittenabstand von 20cm in die Wand bohren. 8” [20 cm] 1,75 cm IPS- 1,25 cm 1,25 cm Zuflußrohr NPT- NPT- zur Wanne Zuflußrohr Zuflußrohr 4.
  • Page 8 RELATED T&S BRASS PRODUCT LINE B-1030 Concealed By- Pass Mixing Valve B-1065 Combination Bath and Shower Fitting T&S BRASS AND BRONZE WORKS, INC. A firm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, T & S Brass-Europe Travelers Rest, SC 29690 ‘De Veenhoeve’...

Table des Matières