Ordinary Maintenance - EPTA Costan GRANVISTA INTEGRAL WL Instructions Pour L'utilisateur

Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
MAINTENANCE: we recommend you check the pH and the concentration of the solution
used at least once a year.

11. ORDINARY MAINTENANCE

ATTENTION! BEFORE STARTING ANY MAINTENANCE OR CLEANING, DISCONNECT THE
EQUIPMENT FROM THE ELECTRICAL POWER SUPPLY USING THE MAIN WALL CUT-OFF
SWITCH (FIG. 17).
IMPORTANT: During maintenance or cleaning operations, be sure that the light in the
working area is sufficient and if necessary, use an additional source of light.
CLEANING THE DISPLAY CASE
1) EVERY WEEK clean the outer surfaces of the display case with mild soap or de-
tergent in lukewarm water only. Wipe carefully with a soft cloth. Never clean it using
inflammable or scouring agents, alcohol, acetone or solvents. NEVER CLEAN THE DI-
SPLAY CASE BY THE USE OF WATER JETS. Clean glass surfaces using glass-cleaning
products exclusively. The use of water is not recommended here, as it may cause scale
to build up.
CAUTION! NEVER WASH OR CLEAN THE UPPER PART OF THE DISPLAY CASE WITH WA-
TER OR LIQUIDS
2) EVERY MONTH clean the inside surfaces following the instructions provided in the
preceding item:
3) Defrost the display case EVERY THREE MONTHS to let the ice that may have formed
between the fins melt. Frost may otherwise prevent correct operation. Proceed as fol-
lows:
• Disconnect the display case from the electrical power supply by the wall main cut-off
switch (fig. 17).
• Empty the appliance, store the contents in cold rooms or refrigerators that are ade-
quate for keeping the requisite preservation temperature.
• Wait until the cold room has reached ambient temperature.
• Clean the inside of the display case thoroughly with mild soap or detergent and luke-
warm water. Wipe carefully with a soft cloth.
• After having carefully checked that the display case is completely dry inside, start
the appliance again by the wall cut-out switch.
• Allow a couple of hours before loading the products back again.
Attention! Disassemble and assemble very slowly, using heavy-duty gloves. It is advi-
sable to have these cleaning operations carried out by authorized service personnel.
ANY MAINTENANCE OPERATION NOT INCLUDED AMONG THE FORMER STEPS MUST BE
CARRIED OUT BY THE AUTHORISED AFTER-SALES SERVICE OR BY QUALIFIED PER-
SONNEL.
GRANVISTA INTEGRAL WL
Epta Spa - Unità locale: Via degli Alpini 14 - 32020 Limana (BL)
ITALIA Tel. 0437/9681 Telefax 0437/967434
41/64
PAGE:
UM000420
N° DOC.