Standby Mode - THOMSON WHP5327 Mode D'emploi

Note
• In the case of interference or poor reception, the
headphone sound is muted and the LED is lit red. An
automatic channel search is started.
• These headphones can also be used as standard wired
headphones. For this purpose, connect the headphone
output on your playback device to the jack socket on
your headphones using the 3.5 mm jack cable (Fig.
2–15).
• Switch off the headphones if they are not being used
and put them back onto the transmitter's charging
contacts (3).
• Make sure that the charging contacts lie on top of
each other.

7.3 Standby mode

• To protect the transmitter and to save power, the
transmitter automatically switches to standby mode if no
audio signal is received for about 5 minutes. The Power
LED (2) then goes out.
• As soon as an audio signal is detected again, the trans-
mitter automatically switches back on and the Power LED
(2) lights up blue.
• To play your device's audio through the headphones,
switch the headphones back on by pressing and holding
the Power button (14) for about 2 seconds.
• The headphones likewise switch off automatically if they
receive no signal from the transmitter for about 5 minutes.
8. Troubleshooting
8.1 No sound
• Make sure that the power supply unit is correctly
connected to the wall socket and to the transmitter's
power socket.
• Check whether the headphones are on.
• The headphone charge level may be too low, in which
case you need to fully charge the batteries.
• Make sure that the desired TV set or audio device is
switched on.
• The headphone volume may be too low.
• The audio signal may be too low. Increase the volume on
your playback device.
• The headphones may be too far from the transmitter.
4
Note – Manual channel search in the case of
connection problems
• In the case of interference or poor reception, the
headphone sound is muted and the LED is lit red.
• Insert two charged AAA batteries into the battery
compartment of the headphones, as described in
Chapter 6.2.
• Connect the transmitter to the outlet using the power
supply unit. DO NOT switch on the transmitter.
• Press and hold the Power button (14) on the head-
phones (receiver) for about 7 seconds until the green
LED begins to flash.
• Now switch on the transmitter. The connection from
the transmitter to the headphones (receiver) is auto-
matically established.
9. Volume control with analogue input selection (for
example, headphone output on TV)
• To ensure clean signal level quality, you should set the
volume of the source (for example, television volume) to
60%.
• Set the volume on the headphones to the minimum level
and increase it gradually, in order to avoid hearing loss.
10. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth
and do not use aggressive cleaning agents.
11. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
12. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com