Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fully charge the battery when using for the rst time.
When the rechargeable battery power runs low, you will hear a short beep and the indicator will
ash red. When you hear the beep, charge the battery.
It takes about 3 hours to charge the battery fully. (It varies depending on service conditions.)
* The headphones cannot be used during charging because Bluetooth is disconnected.
1
Connect the included USB cable (the micro USB
terminal side) to the headphone battery jack.
Computer
2
Connect the USB cable (the Type A side) to the computer and start charging.
3
During charging, the indicator turns on/ ashes as follows:
Lit red: Charging
Lit blue: Charging complete
How to Connect
About Pairing
To connect the headphones to a Bluetooth device, the headphones need to pair (register) with the
device. Once they are paired, you don't need to pair them again.
However, you will need to pair again in the following cases:
・ If the headphones are deleted from the Bluetooth device connection history,
・ If the headphones are sent out for repair,
・ If the headphones are paired with 9 devices or more.
(The headphones can be paired with up to 8 devices. When you pair with a new device after pairing
with 8 devices, pairing information for the device with the oldest connection date will be overwritten
by information for the new device.)
USB port
Type A
USB charging cable (included)
How to Charge
Battery
jack
Micro USB terminal
English
7
Publicité
Table des Matières
