Maintenance And Cleaning - brennenstuhl City SH 8005 IP44 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
Operating Instructions
D
Setting the controllers (see Fig� D)
Set the LUX controller to the () symbol and wait for a few seconds. Make sure that the TIME
controller is set to minimum (–). The lamp will now turn on and remain on for several seconds.
Adjust the motion detector vertically so that it captures the desired area. Have a person walk
across the area to be detected and change the sensor angle until the lamp turns on from the
movement (see Fig. C). Set the TIME controller to the desired time.
To set the LUX threshold, at which the light should automatically turn on at night, turn the LUX
controller from daylight to night. Notice: If the light needs to be turned on earlier, e.g., at dusk,
wait for the desired light level, then slowly turn the LUX controller toward the daylight position
while someone walks through the centre of the sensor range. Let the controller go when the light
turns on.
Continuous light function
By installing a power switch (wall light switch) in the power supply line, models with motion
detectors can be set to remain continuously lit:
1� Switching on continuous light:
Quickly turn the switch ON and OFF twice (within 2 sec.). The lamp will be set to remain
continuously lit for 4 hours. Then it will automatically switch back to motion sensor mode.
2� Switching off continuous light:
Turn the switch ON and OFF once. The lamp will switch off and go into motion sensor mode.

MAINTENANCE AND CLEANINg

The LED lamp does not contain any components that require maintenance. The LEDs cannot be
replaced. To clean, use only a dry or lightly moistened cloth and do not use any cleaning solvents,
acidic cleaning agents, etc.
DISPOSAL
Dispose of electrical devices in an environmentally responsible manner!
Do not dispose of electrical devices with household rubbish
In accordance with Directive 2012/19/EU on waste electrical and electronic equipment,
used electrical equipment must be collected separately and reused or recycled in an
environmentally responsible manner. Please contact your local authorities for available
disposal options for your worn-out device.
10
BA_City_LED-Premium_0486444_150313.indd 10
Premium LED spotlight
13.03.15 09:20

Publicité

Table des Matières
loading

Table des Matières