Adjusting The Motion Detector; Maintenance And Cleaning - brennenstuhl L CN 110 PIR IP44 Mode D'emploi

Chip LED Light

aDjusTINg THE MOTION DETECTOr

There are three knobs on the underside of the light (see Fig. 3).
setting the time (TIME):
Use the TIME knob to set how long the light remains on after the last
movement (between 10 seconds and 4 minutes). Turn the TIME knob
clockwise to increase the time span.
sensitivity (sENs):
This knob can be used to adjust the sensitivity of the sensor. Turn the
SENS knob clockwise to increase sensitivity.
Light setting (LuX):
The LUX setting determines how dark it must be before the sensor
turns on the light. The sun symbol () shows that the sensor is active
during the day and at night. If the knob is set to moon (), the sensor
only works at night. To adjust the sensor, wait until the desired level
of ambient light has been reached. Turn the knob all the way to the
moon symbol (), then turn the knob slowly towards the sun symbol
() until the light turns on if movement is detected.
The light will thereafter turn on automatically at the preset level of
darkness whenever a movement is detected.
Motion detector:
Detection range:
Time setting:

MaINTENaNCE aND CLEaNINg

All maintenance work must be carried out by a qualified electrician.
PLEASE NOTE: The LED light does not contain parts that need
servicing. The LED light source cannot be replaced.
If necessary, replace the entire light.
Do not use solvents, corrosive cleaners or the like.
Use a dry or slightly moist cloth for cleaning ONLY.
A_Chip_Leuchte_Stationaer_0472362_1507.indd 11
Operating Instructions
passive infrared sensor
up to 12 m / up to 180 ° (horizontal)
approx. 10 sec–4 min
D
11
09.07.15 09:50