Connecting The Device To The Power Supply - DOMUS LINE K-PAD Manuel D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

INSTALLATION MANUAL
WARNING:
Safety is guaranteed if these instructions are followed
and therefore they must be kept. Installation may
require the involvement of qualified personnel. Before
proceeding with installation of the device ensure that
the environmental conditions are in compliance with
and suitable for the product characteristics. Before any
operation on the device disconnect mains power.
INSTALLATION:
- Fasten the bracket (A), using the screws in the pack
(B), on the installation surface in the position wanted.
To install the fixture correctly, fasten the bracket (A) so
it is against the wall and at right angles to it (fig. 1-2).

CONNECTING THE DEVICE TO THE POWER SUPPLY _

Tunable White dynamic light configuration D-MOTION
fig.3
- Connect the K-PAD D-M power supply cable to one of
the light colour dynamic adjustment systems
D-MOTION sold separately and with power at least
10% greater than the total load. For the total load
calculation check plate data printed on the product
label.
- For installation and operation of the light colour
dynamic adjustment system see the specific item's
manual.
EN
- Then connect the light colour dynamic adjustment
system to a safe power supply with 24Vdc stabilised
voltage (sold separately) and with power at least 10%
higher than the total load. For the total load calculation
check plate data printed on the product label.
- If more than one device must be connected to the
power supply unit ensure that the total sum of the
power absorbed by the devices (check the plate data
shown on the product label) does not exceed the
maximum power permitted both by the dynamic
adjustment system and by the Converter.
WARNING
- The LED module of these devices is not replaceable.
- The external flexible cable is not replaceable.
- In case of failure it must be entirely replaced the
entire unit.
WARRANTY
DOMUS Line guarantees the product only if powered
with a Converter supplied by us.
The warranty's general terms and conditions for this
device are available at
CAUTION
USE ONLY 24Vdc CLASS 2 POWER UNIT
www.domusline.com

Publicité

Table des Matières
loading

Table des Matières