Yearly Maintenance; Lubrication - Husqvarna FS7000 DL Manuel D'utilisation

Yearly maintenance

Replace outer and inner air filter
Remove the rear cover by opening the 3 air filter housing
clamps and pulling the housing off. Replace both filters and
refit them in reverse order.
CAUTION! The 3 air filter housing clamps
!
can not be closed unless the outer air filter
is properly installed.
Check coolant freeze protection
Maintain 50/50 mixture of glycol and water. For more
information, see the "Technical data" section.

Lubrication

The image shows all the lubrication points (8 grease nipples).
Clean the nipple. Replace broken or blocked nipples.
• Lubricate the front wheels.
• Lubricate the front axle pivot bearings.
• Lubricate the blade shaft. Two pumps at each end.
• Lubricate hydraulic cylinder pivot pin.
40 –
English
MAINTENANCE AND SERVICE
• Lubricate rear axle bearing.